Gå til innhold

Anbefalte innlegg

Skrevet

Bolt on til M30 motor

Customer to do:

-- Replace Throttle Position Switch with Throttle Position Sensor e.g. from M50 engine (not included in delivery)

- Change Engine Management

- START ENGINE !

- do your own setup

Features:

- full compatible to MSextra Software

- build your own setup

- MS2 onboard / Firmware MS2extra

- free Software / Open Source

- Fuel Table 16x16

- Ignition Table 12x12

- USB Conector

- Widebandlambdacontroller JAW on Board (JAW Processor not included)

- Upgradeable to single coils (option)

- Knocksensor Input (option)

- supports low impedance injectors

- supports stock idle valves

- user programable relay output

- electronical boost control (option)

- Tacho output

- permanent Barometric correction prepared (option)

- supports CAN Bus (option)

Only for cars with BOSCH devicesv

Opprett en konto eller logg inn for å kommentere

Du må være et medlem for å kunne skrive en kommentar

Opprett konto

Det er enkelt å melde seg inn for å starte en ny konto!

Start en konto

Logg inn

Har du allerede en konto? Logg inn her.

Logg inn nå
  • Hvem er aktive   0 medlemmer

    • Ingen innloggede medlemmer aktive
×
×
  • Opprett ny...