Gå til innhold
View in the app

A better way to browse. Learn more.

Bimmers.no | BMW Forum

A full-screen app on your home screen with push notifications, badges and more.

To install this app on iOS and iPadOS
  1. Tap the Share icon in Safari
  2. Scroll the menu and tap Add to Home Screen.
  3. Tap Add in the top-right corner.
To install this app on Android
  1. Tap the 3-dot menu (⋮) in the top-right corner of the browser.
  2. Tap Add to Home screen or Install app.
  3. Confirm by tapping Install.
🔧 Vi fornyer Bimmers.no! Oppgraderinger gjennom november kan medføre periodevis ustabilitet. Takk for tålmodigheten!

Bytte av glødeplugger + rele BMW 120d e87 04 modell

Featured Replies

Skrevet

Det bør ivertfall gjørest på "varm" motor (plugger) og lurer på om innsuget må av?
Rele skal kunnes ta underfrå. 

Ser ut som om du har M47TU2D20.

 

Fann ein litt røff forklaring på glødeplugger. Håper ivertfall det kan hjelpe :)

- Open bonnet

- remove engine cover
- remove both left and right braces (diagonal from strut top to bulkhead)
- remove micro filter
- remove lower microlter housing along with the ECU and brake master cylinder covers
- remove the rear section of the engine cover
- disconnect front main boost hose (spring clip plastic connected pipe front for inlet manifold)
- disconnect throttle flap electrical connector
- unscrew the jubilee clip holding the EGR gas feed
- pull off the vacuum pipe to EGR
- disconnect the vacuum pipe to the swirl flap valve (reach down the back of inlet manifold, underneath on the n/s of the engine at the very back if the inlet manifold)
- undo all the inlet manifold nuts (two sets)
- lift off inlet manifold
- remove the electrical caps to the glow plugs
- undo glow plugs (deep reach socket required)
- replace with new glow plugs and torque back up (20nm iirc)
- replace electrical caps
- refit the inlet manifold and torque up (18nm iirc)
- refit vacuum hoses to both swirl flap actuator and EGR
- refit electrical connectors and boost pipe
- refit all plastics

 

Gløderele sett fra oven:

IMAG0300_zpsqwrqwqi_edit_1421435145547_z

Endret av Sammyen

Skrevet
  • Forfatter

OK greit å vite! Ja mener innsuget skal av ja. Bør forresten batteri kobles fra før man begynner jobben?

Det hadde vert supert!

Opprett en konto eller logg inn for å kommentere

Hvem er aktive 0

  • Ingen innloggede medlemmer aktive

Account

Navigation

Søk

Søk

Configure browser push notifications

Chrome (Android)
  1. Tap the lock icon next to the address bar.
  2. Tap Permissions → Notifications.
  3. Adjust your preference.
Chrome (Desktop)
  1. Click the padlock icon in the address bar.
  2. Select Site settings.
  3. Find Notifications and adjust your preference.